The Federal Aviation Administration has stopped installing new network routers and disabled a function on 60 similar units after a router problem led to the nationwide ground stop.
Investigators are examining equipment installed by federal contractor L3Harris, which was replacing old copper wire with fiber-optic lines when the network became unstable on Friday.
The ground stop lasted more than four hours.
People were interested in these podcasts
The agency said its initial investigation points to two locations: a radar site in Amarillo, Texas, and a radio communications site in El Dorado, Arkansas. L3Harris had been working at the El Dorado site, including deploying a new router.
Data began flooding the FAA’s network at a rate of 1,000 connection attempts every four to five seconds, the FAA said. That caused instability in aircraft communications and radar feeds at 17 of the agency’s 22 Air Route Traffic Control Centers.
The FAA said L3Harris blocked the two locations, which stabilized the network, and the agency disabled the routers’ broadcasting function as a precaution.
For now, the agency is reportedly relying on its older Cisco routers to keep the network running.
The agency said every aircraft landed safely, that some radio frequencies and radar feeds stayed operational, and that it has no indication the incident was a cyberattack.
The two routers are undergoing testing at L3Harris’ headquarters in Florida, with engineers from the FAA, Juniper Networks and Cisco assisting, Transportation Secretary Sean Duffy said.
The cause has not been determined, but Mr. Duffy said officials are weighing whether the router was faulty or the installation was flawed.
A spokesperson for Hewlett Packard Enterprise, which makes the Juniper routers, said the units appeared to function as designed.
L3Harris said it’s supporting the FAA’s investigation and has completed more than 70% of the planned conversion from copper to fiber.
Democrats on the Senate Commerce Committee said they believe only about 400 of more than 3,600 routers have been installed. They asked the FAA to stop installing the devices until the root cause is identified.

Please read our comment policy before commenting.